Matches in DBpedia 2016-04 for { <http://wikidata.dbpedia.org/resource/Q3788482> ?p ?o }
Showing triples 1 to 47 of
47
with 100 triples per page.
- Q3788482 subject Q6378466.
- Q3788482 subject Q6456862.
- Q3788482 subject Q6498192.
- Q3788482 subject Q6539533.
- Q3788482 subject Q6901851.
- Q3788482 subject Q7163208.
- Q3788482 subject Q7334837.
- Q3788482 abstract "IEEE 1541-2002 is a standard issued by the Institute of Electrical and Electronics Engineers (IEEE) concerning the use of prefixes for binary multiples of units of measurement related to digital electronics and computing.While the International System of Units (SI) defines multiples based on powers of ten (like k = 103, M = 106, etc.), a different definition is sometimes used in computing, based on powers of two (like k = 210, M = 220, etc.) This is due to the use of binary addressing for computer memory locations.In the early years of computing, there was no significant error in using the same prefix for either quantity (210 = 1024 and 103 = 1000 are equal, to two significant figures). Thus, the SI prefixes were borrowed to indicate nearby binary multiples for these computer-related quantities.Meanwhile, manufacturers of storage devices, such as hard disks, traditionally used the standard decimal meanings of the prefixes, and decimal multiples are used for transmission rates and processor clock speeds as well. As technology improved, all of these measurements increased. As the binary meaning was extended to higher prefixes, the difference between the two meanings became more pronounced.This is a common cause of confusion among users that see those amounts reported inconsistently, especially as capacities become bigger and bigger and the absolute error increases. This has even resulted in litigation against hard drive manufacturers, who report drive capacities in standard decimal multiples of bytes, while some operating systems report the size using the larger binary interpretation of traditional prefixes.Moreover, there is not a consistent use of the symbols to indicate quantities of bits and bytes — the unit symbol "Mb", for instance, has been widely used for both megabytes and megabits. IEEE 1541 sets new recommendations to represent these quantities and unit symbols unambiguously.After a trial period of two years, in 2005, IEEE 1541-2002 was elevated to a full-use standard by the IEEE Standards Association, and was reaffirmed on 27 March 2008.".
- Q3788482 wikiPageExternalLink si_brochure.
- Q3788482 wikiPageExternalLink www.ieee.org.
- Q3788482 wikiPageExternalLink standards.ieee.org.
- Q3788482 wikiPageExternalLink 305recomm.html.
- Q3788482 wikiPageWikiLink Q1056761.
- Q3788482 wikiPageWikiLink Q12457.
- Q3788482 wikiPageWikiLink Q131566.
- Q3788482 wikiPageWikiLink Q1378146.
- Q3788482 wikiPageWikiLink Q1406.
- Q3788482 wikiPageWikiLink Q15028.
- Q3788482 wikiPageWikiLink Q173156.
- Q3788482 wikiPageWikiLink Q179310.
- Q3788482 wikiPageWikiLink Q193858.
- Q3788482 wikiPageWikiLink Q194158.
- Q3788482 wikiPageWikiLink Q229478.
- Q3788482 wikiPageWikiLink Q3234414.
- Q3788482 wikiPageWikiLink Q341.
- Q3788482 wikiPageWikiLink Q39162.
- Q3788482 wikiPageWikiLink Q4439.
- Q3788482 wikiPageWikiLink Q47574.
- Q3788482 wikiPageWikiLink Q518730.
- Q3788482 wikiPageWikiLink Q568496.
- Q3788482 wikiPageWikiLink Q6378466.
- Q3788482 wikiPageWikiLink Q6456862.
- Q3788482 wikiPageWikiLink Q648403.
- Q3788482 wikiPageWikiLink Q6498192.
- Q3788482 wikiPageWikiLink Q6539533.
- Q3788482 wikiPageWikiLink Q6583973.
- Q3788482 wikiPageWikiLink Q6901851.
- Q3788482 wikiPageWikiLink Q7163208.
- Q3788482 wikiPageWikiLink Q7334837.
- Q3788482 wikiPageWikiLink Q7672057.
- Q3788482 wikiPageWikiLink Q7806021.
- Q3788482 wikiPageWikiLink Q8799.
- Q3788482 wikiPageWikiLink Q8805.
- Q3788482 wikiPageWikiLink Q911691.
- Q3788482 wikiPageWikiLink Q9135.
- Q3788482 comment "IEEE 1541-2002 is a standard issued by the Institute of Electrical and Electronics Engineers (IEEE) concerning the use of prefixes for binary multiples of units of measurement related to digital electronics and computing.While the International System of Units (SI) defines multiples based on powers of ten (like k = 103, M = 106, etc.), a different definition is sometimes used in computing, based on powers of two (like k = 210, M = 220, etc.) This is due to the use of binary addressing for computer memory locations.In the early years of computing, there was no significant error in using the same prefix for either quantity (210 = 1024 and 103 = 1000 are equal, to two significant figures). ".
- Q3788482 label "IEEE 1541-2002".