Matches in DBpedia 2016-04 for { <http://wikidata.dbpedia.org/resource/Q831990> ?p ?o }
Showing triples 1 to 76 of
76
with 100 triples per page.
- Q831990 subject Q7153752.
- Q831990 abstract "A reference designator unambiguously identifies a component in an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. R13, C1002. The number is sometimes followed by a letter, indicating that components are grouped or matched with each other, e.g. R17A, R17B.IEEE 315 contains a list of Class Designation Letters to use for electrical and electronic assemblies. For example, the letter R is a reference prefix for the resistors of an assembly, C for capacitors, K for relays.IEEE 200-1975 or "Standard Reference Designations for Electrical and Electronics Parts and Equipments" is a standard that was used to define referencing naming systems for collections of electronic equipment. IEEE 200 was ratified in 1975. The IEEE renewed the standard in the 1990s, but withdrew it from active support shortly thereafter. This document also has an ANSI document number, ANSI Y32.16-1975.This standard codified information from, among other sources, a United States military standard MIL-STD-16 which dates back to at least the 1950s in American industry.To replace IEEE 200-1975, ASME, a standards body for mechanical engineers, initiated the new standard ASME Y14.44-2008.This standard, along with IEEE 315-1975, provide the electrical designer with guidance on how to properly reference and annotate everything from a single circuit board to a collection of complete enclosures.It breaks down a system into units, and then any number of sub-assemblies. The unit is the highest level of demarcation in a system and is always a numeral. Subsequent demarcation are called assemblies and always have the Class Letter "A" as a prefix following by a sequential number starting with 1. Any number of sub-assemblies may be defined until finally reaching the component. Note that IEEE-315-1975 defines separate class designation letters for separable assemblies (class designation 'A') and inseparable assemblies (class designation 'U'). Inseparable assemblies—i.e., "items which are ordinarily replaced as a single item of supply"—are typically treated as components in this referencing scheme.Examples: 1A12A2R3 - Unit 1, Assembly 12, Sub-assembly 2, Resistor 3 1A12A2U3 - Unit 1, Assembly 12, Sub-assembly 2, Inseparable Assembly 3Especially valuable is the method of referencing and annotating cables plus their connectors within and outside assemblies.Examples: 1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44) 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45)A cable connecting these two might be: 1A1W35 - In the assembly A1 is a cable called W35.Connectors on this cable would be designated: 1A1W35P1 1A1W35P2ASME Y14.44-2008 continues the convention of Plug P and Jack J when assigning references for electrical connectors in assemblies where a J (or jack) is the more fixed and P (or plug) is the less fixed of a connector pair, without regard to the gender of the connector contacts.The construction of reference designators is covered by IEEE 200-1975/ANSI Y32.16-1975 (replaced by ASME Y14.44-2008) and IEEE-315-1975. The table below lists designators commonly used, and does not necessarily comply with the standard.".
- Q831990 wikiPageWikiLink Q1045991.
- Q831990 wikiPageWikiLink Q106370.
- Q831990 wikiPageWikiLink Q10860300.
- Q831990 wikiPageWikiLink Q1139135.
- Q831990 wikiPageWikiLink Q1146554.
- Q831990 wikiPageWikiLink Q1148571.
- Q831990 wikiPageWikiLink Q1159201.
- Q831990 wikiPageWikiLink Q11653.
- Q831990 wikiPageWikiLink Q11656.
- Q831990 wikiPageWikiLink Q11658.
- Q831990 wikiPageWikiLink Q1269728.
- Q831990 wikiPageWikiLink Q1277396.
- Q831990 wikiPageWikiLink Q131214.
- Q831990 wikiPageWikiLink Q131502.
- Q831990 wikiPageWikiLink Q1347410.
- Q831990 wikiPageWikiLink Q13635143.
- Q831990 wikiPageWikiLink Q1366737.
- Q831990 wikiPageWikiLink Q1417986.
- Q831990 wikiPageWikiLink Q1428337.
- Q831990 wikiPageWikiLink Q1469893.
- Q831990 wikiPageWikiLink Q1544018.
- Q831990 wikiPageWikiLink Q1552671.
- Q831990 wikiPageWikiLink Q1587699.
- Q831990 wikiPageWikiLink Q162869.
- Q831990 wikiPageWikiLink Q170475.
- Q831990 wikiPageWikiLink Q173350.
- Q831990 wikiPageWikiLink Q174053.
- Q831990 wikiPageWikiLink Q175973.
- Q831990 wikiPageWikiLink Q176097.
- Q831990 wikiPageWikiLink Q1778158.
- Q831990 wikiPageWikiLink Q180586.
- Q831990 wikiPageWikiLink Q180805.
- Q831990 wikiPageWikiLink Q182221.
- Q831990 wikiPageWikiLink Q18670447.
- Q831990 wikiPageWikiLink Q187868.
- Q831990 wikiPageWikiLink Q188674.
- Q831990 wikiPageWikiLink Q190241.
- Q831990 wikiPageWikiLink Q194120.
- Q831990 wikiPageWikiLink Q204157.
- Q831990 wikiPageWikiLink Q208443.
- Q831990 wikiPageWikiLink Q210793.
- Q831990 wikiPageWikiLink Q211058.
- Q831990 wikiPageWikiLink Q2119531.
- Q831990 wikiPageWikiLink Q249997.
- Q831990 wikiPageWikiLink Q25504.
- Q831990 wikiPageWikiLink Q267298.
- Q831990 wikiPageWikiLink Q3072260.
- Q831990 wikiPageWikiLink Q327065.
- Q831990 wikiPageWikiLink Q338763.
- Q831990 wikiPageWikiLink Q3574371.
- Q831990 wikiPageWikiLink Q3629214.
- Q831990 wikiPageWikiLink Q385520.
- Q831990 wikiPageWikiLink Q46384.
- Q831990 wikiPageWikiLink Q465115.
- Q831990 wikiPageWikiLink Q466950.
- Q831990 wikiPageWikiLink Q5320.
- Q831990 wikiPageWikiLink Q5321.
- Q831990 wikiPageWikiLink Q5322.
- Q831990 wikiPageWikiLink Q5325.
- Q831990 wikiPageWikiLink Q5339.
- Q831990 wikiPageWikiLink Q5530572.
- Q831990 wikiPageWikiLink Q5531000.
- Q831990 wikiPageWikiLink Q570.
- Q831990 wikiPageWikiLink Q622970.
- Q831990 wikiPageWikiLink Q7153752.
- Q831990 wikiPageWikiLink Q72313.
- Q831990 wikiPageWikiLink Q7705800.
- Q831990 wikiPageWikiLink Q80831.
- Q831990 wikiPageWikiLink Q83341.
- Q831990 wikiPageWikiLink Q83913.
- Q831990 wikiPageWikiLink Q872157.
- Q831990 wikiPageWikiLink Q877055.
- Q831990 comment "A reference designator unambiguously identifies a component in an electrical schematic or on a printed circuit board. The reference designator usually consists of one or two letters followed by a number, e.g. R13, C1002. The number is sometimes followed by a letter, indicating that components are grouped or matched with each other, e.g. R17A, R17B.IEEE 315 contains a list of Class Designation Letters to use for electrical and electronic assemblies.".
- Q831990 label "Reference designator".