Matches in DBpedia 2016-04 for { <http://wikidata.dbpedia.org/resource/Q1755092> ?p ?o }
Showing triples 1 to 21 of
21
with 100 triples per page.
- Q1755092 subject Q10326370.
- Q1755092 subject Q6375545.
- Q1755092 subject Q9011662.
- Q1755092 abstract "The melt flow index (MFI) is a measure of the ease of flow of the melt of a thermoplastic polymer. It is defined as the mass of polymer, in grams, flowing in ten minutes through a capillary of a specific diameter and length by a pressure applied via prescribed alternative gravimetric weights for alternative prescribed temperatures. Polymer processors usually correlate the value of MFI with the polymer grade that they have to choose for different processes, and most often this value is not accompanied by the units, because it is taken for granted to be g/10min. Similarly, the test load conditions of MFI measurement is normally expressed in kilograms rather than any other units. The method is described in the similar standards ASTM D1238 and ISO 1133.Melt flow rate is an indirect measure of molecular weight, with high melt flow rate corresponding to low molecular weight. At the same time, melt flow rate is a measure of the ability of the material's melt to flow under pressure. Melt flow rate is inversely proportional to viscosity of the melt at the conditions of the test, though it should be borne in mind that the viscosity for any such material depends on the applied force. Ratios between two melt flow rate values for one material at different gravimetric weights are often used as a measure for the broadness of the molecular weight distribution.Melt flow rate is very commonly used for polyolefins, polyethylene being measured at 190 °C and polypropylene at 230 °C. The plastics engineer should choose a material with a melt index high enough that the molten polymer can be easily formed into the article intended, but low enough that the mechanical strength of the final article will be sufficient for its use.".
- Q1755092 thumbnail Melt_flow_index.jpg?width=300.
- Q1755092 wikiPageExternalLink melt-flow-index-deluxe.
- Q1755092 wikiPageWikiLink Q10326370.
- Q1755092 wikiPageWikiLink Q11423.
- Q1755092 wikiPageWikiLink Q12453.
- Q1755092 wikiPageWikiLink Q143429.
- Q1755092 wikiPageWikiLink Q146174.
- Q1755092 wikiPageWikiLink Q2609080.
- Q1755092 wikiPageWikiLink Q3230.
- Q1755092 wikiPageWikiLink Q380677.
- Q1755092 wikiPageWikiLink Q621977.
- Q1755092 wikiPageWikiLink Q6375545.
- Q1755092 wikiPageWikiLink Q81163.
- Q1755092 wikiPageWikiLink Q9011662.
- Q1755092 comment "The melt flow index (MFI) is a measure of the ease of flow of the melt of a thermoplastic polymer. It is defined as the mass of polymer, in grams, flowing in ten minutes through a capillary of a specific diameter and length by a pressure applied via prescribed alternative gravimetric weights for alternative prescribed temperatures.".
- Q1755092 label "Melt flow index".
- Q1755092 depiction Melt_flow_index.jpg.