Matches in DBpedia 2015-10 for { ?s ?p "In solid mechanics, the Johnson–Holmquist damage model is used to model the mechanical behavior of damaged brittle materials, such as ceramics, rocks, and concrete, over a range of strain rates. Such materials usually have high compressive strength but low tensile strength and tend to exhibit progressive damage under load due to the growth of microfractures.There are two variations of the Johnson-Holmquist model that are used to model the impact performance of ceramics under ballistically delivered loads. These models were developed by Gordon R. Johnson and Timothy J. Holmquist in the 1990s with the aim of facilitating predictive numerical simulations of ballistic armor penetration. The first version of the model is called the 1992 Johnson-Holmquist 1 (JH-1) model. This original version was developed to account for large deformations but did not take into consideration progressive damage with increasing deformation; though the multi-segment stress-strain curves in the model can be interpreted as incorporating damage implicitly. The second version, developed in 1994, incorporated a damage evolution rule and is called the Johnson-Holmquist 2 (JH-2) model or, more accurately, the Johnson-Holmquist damage material model."@en }
Showing triples 1 to 1 of
1
with 100 triples per page.
- Johnson–Holmquist_damage_model abstract "In solid mechanics, the Johnson–Holmquist damage model is used to model the mechanical behavior of damaged brittle materials, such as ceramics, rocks, and concrete, over a range of strain rates. Such materials usually have high compressive strength but low tensile strength and tend to exhibit progressive damage under load due to the growth of microfractures.There are two variations of the Johnson-Holmquist model that are used to model the impact performance of ceramics under ballistically delivered loads. These models were developed by Gordon R. Johnson and Timothy J. Holmquist in the 1990s with the aim of facilitating predictive numerical simulations of ballistic armor penetration. The first version of the model is called the 1992 Johnson-Holmquist 1 (JH-1) model. This original version was developed to account for large deformations but did not take into consideration progressive damage with increasing deformation; though the multi-segment stress-strain curves in the model can be interpreted as incorporating damage implicitly. The second version, developed in 1994, incorporated a damage evolution rule and is called the Johnson-Holmquist 2 (JH-2) model or, more accurately, the Johnson-Holmquist damage material model.".